A&i Parts
JD 466 540 W Clutch, Complete Shaft, A&i, New
AE74294N
Constant velocity driveline, 540 rpm. Driveline Length: 45" C-to-C of Cross Bearings. Tractor end: 1-3/8" - 6 Spline; Implement end: 1-3/8" - 6 Spline Clutch. Clutch torque: 1800 nm - 15,930 lbs. Fits John Deere Round Balers.
Original Walterscheid part.
Implement: 1 3/8" 6 Spl. Clutch
Length: 45" C to C of Cross Bearings.
Replaces: AE74294SPL
Torque Setting: 1800 nm - 15930 in. lbs
Tractor: 1 3/8" 6 Spl.
Pto Driveline 540 X11/4 Rnd Shear Pin, A&i, New
CS44514
Posthole Digger Driveline Assembly, size 4. Driveline minimum C-to-C is 45" (1145 mm), maximum C-to-C length is 71" (1800 mm), total collapsed length is 53" (1345 mm). Tractor ends: 1-3/8" 6 Spline and implement ends are 1-1/4" round bore with 3/8" pin hole. Driveline rated as category 3 (35 hp). Fits Bush Hog, Land Pride, and Rhino applications.
It may be necessary to cut this driveline to length. Verify the length by ensuring that sufficient overlap of the drive tubes exists in all working positions without the possibility of bottoming out.
Genuine alternative to original part.
C to C Max: 1800 mm/ 71"
C to C Min: 1145 mm/ 45"
Category: 3 (35HP)
Implement: 1 1/4" RB WITH 3/8" PH
Size: 4
Total Collapsed Length: 1345 mm/ 53"
Tractor: 1 3/8" -6
540 CV Less Imp Yoke, A&i, New
700709854,BCL64810
Draw Bar Stub, A&i, New
397065R1
Female Tube Small 1000 CV Joint, A&i, New
AE74042, DT535921N
Tractor Half 540, CV, A&i, New
WT58481A
Inner Tube Yoke, A&i, New
BP204056861-CS