Corn header, feed house 29.5 in x 8ft.4in high, 34 in row spacing, point was bent in a little

New 10ft green plastic & metal feed trough

Lilliston 6610 Cultivator, 3pt, 8 row, 20ft wide, several gauge wheels missing 8 row 30"

Lilliston 6610 Cultivator, 3pt, 8 row, 20ft wide, hydraulic fold, 8 row 30"

10ft wide with caddy, 540 PTO, working order

PTO A-2

MF 3165 Tractor, 14.9-28 rear, 540 PTO, 3pt, no draw bar

MD Products Stud King Header Trailer, 32ft, no title, sn # 1904

1997 Truck single axle, 10R-22.5 tires, 11ft bed with rollers, winch cat 3116 engine

6 speed transmission, 5929 hrs, 124,349 mi, has title, runs and drives

28ft x 6' 8" cattle trailer 235/8.5R 16 tires, 2 axle missing, 3rd axle

metal floor rusted and welds Jack is broken 1 corteca side

Mixer Wagon, pull type, 540 PTO rusted holes inside of tub, patched on outside, multiple welds

540 RPM PTO,12.5-15 tires, runs and operates, (2) mixing augers PTO A-2

Shredder, 3pt., 540 PTO, 4ft, has crack in frame rail, PTO shaft on shredder, gear box turns

Box blade, 3pt., 6ft wide, has ripper teeth

Tractor w/ Loader and JD 485 Backhoe attachment, 525 hrs

16.9-28 rear, 9.5-24 front, 2 remotes, 540 pto, MFD, attachment w/ 16in

JD 1600 Hay Cutter, pull type, 14ft wide, 540 PTO

Roto-mix VXT 505 Vertical Express runs & operates, shredded, new extra parts that cost $1,500.00

New 8' shredder, 3 pt.

JD round baler, twine, has monitor

PTO F-4 Monitor upstairs

155 Massey Ferguson tractor salvage, 18.4-8 rear, 540 PTO, 3pt., 2 remotes, TERP

Salvage Tractor 8-16 rear tires , 3pt, 540 PTO, no remotes, will not move

Chevrolet truck, single axle, no brakes, has not ran in a while, 2 cylinder hoist

5 speed transmission with 2 speed, has title

Cotton stripper, 13 ft header, 18.4-26 front tires, motor turns over, needs starter

Salvage Tractor, 4x4, burnt, has ROPS with roof

UTV, starts and runs but sputters after 10 min, approx 200 hrs

Bobcat 811, Backhoe, 2ft bucket, skidsteer attach, back hoes attachment

Vermeer R23, pull type, Twin Rake, Hydraulic Rake several welds

CAT D5C dozer, 3046 engine, 8ft 6 way blade, ripper, runs and drives

700 JD hydraulic rake, several welds

Ford 700 truck, 3208 cat engine, no welder & air compressor, 5 speed/2 speed axle, 10.00-20 tires

runs and drives, possible title

300 McCormick salvage tractor, 1 remote, 540 PTo, 12-38 tires, tricycle front, propane

motor is stuck

400 McCormick salvage tractor,1 remote,540 PTO,13.6-38 tires,has loader with 3ft wide bucket,propane

Moto has sparking compression, fires on starting fluid, motor should run with LP tank filled

Salvage Tractor21.5-16.1 rear tires, 2 hydraulic remotes, no 3pt., motor turns over

fuel lines are missing, wires are all cut

Shipping container, 40 ft long, 9ft 6in tall, like new

IH 5500 chisel plow, 3 pt., 10ft wide, 11 shanks

Skid steer pallet fork, double bar slide

Salvage JD 333G, Skid steer, burnt, has trax

Round baler, 4ft baler, twine ,automatic tie, 540 PTO

Salvage Ford 1000 tractor, 3pt., 540 PTO, 11.2-24 rear tires, Bad injection pump

21 ft wide, 3 pt, missing gauge wheels, missing 1 spring, with wings, 41 shank, several welds

22ft field cultivator with harrows, cylinders, 3pt hydraulic fold, salvage

Salvage JD 2955 Tractor, 2 remotes, 540 PTO, 18.4-34 tires, TERP

Tractor with Great Bend 2144 loader, left hand reverser, 2 hydraulic remotes, 540 RPM PTO

runs and drives, out of an estate

Yanmar YM1610D, Tractor, 540 PTO, 3pt, no remote, MFD,385/65D 22.5 rear, 31x15.50 front tires

needs head gasket

Superstar 6150 Loader, off JD 4850, , w/hay spear, no joy stick, brackets, stands, self leveling

7ft Bucket, quick attach, also fits a 4440 John Deere if you add a plate, nice loader, forks bent

round bale unroller

JD 146 Loader ,off JD 2440, with joystick, 6ft bucket

Loader ONLY

Rock Flex Front 20" Rear 21" 35 ft

Anhydrous Applicator , 22 in spacing, 8 shank 3 pt,, 13 ft wide, hitch, spring loaded

Grinder Mixer, pull type, 8" unloading auger, 9" loading auger, needs repair

Loader with brackets, 5ft bucket, fits 7000 Ford Tractor

Salvage self-propelled sprayer, cab, air, Raven Viper Pro monitor, fire damage engine compartment,

Cab untouched

Kubota Zd28 Lawn Mower

JD 566 baler, has monitor and PTO, 540 PTO, twine, 540 PTO

14 ft grain drill

F150 PU, tool box, automatic, crew cab, AC works, hole in timing cain cover, Fuel tank doesn't go

30 ft, Header only, no trailer

29 ft Tandem disc, rock flex, hydraulic fold, 20" front, 23" rear blades

10 ft Bushhog 3 point hydraulic blade, nice blade

2) 320/90R 54 tires & rims

Mahindra 4500 Salvage Tractor, 1 remote, 540 PTO, 13.6-28 tires, roof, ROPS, Terp

SUV, 245/60 R18 tires, 4 doors, runs & drives, 3.6 liter V-6 engine, automatic transmission

Salvage title, Cold AC, damage to left front fender & door

Salvage MF 2775 Tractor, 1 remote, 1000 PTO, 20.8-38 tires, PTO, shaft broken, TERP

backglass and front side glass, has cab

Loader with brackets, hay spear, no joystick, Fits 4430-4455 John Deere tractors.

Vermeer 605J Round Baler

Case David Brown Salvage Tractor, TERP, 2 remotes, 540 PTO, 18.4-30 tires

Front-end loader, 8ft bucket , fits CX100 Case IH MFD, joy stick

Mounting brackets

Excavator, no attachments, works fine, several leaks, cab air

Tractor, no remotes, 540 PTO, 11.2-24 tires, diesel engine, 27 h.p., runs & drives, nice tractor

G113 312-Linkage Contractors' Grapple for excavator

Cultivator, 6 row 38in, 3 point

2006 John Deere cotton stripper, cab, air, 3589 engine hours, 3011 machine hours,

8 row 30in John Deere header, 23.1-26 front tires, 14.9-24 rear tires, monitor, stripping cotton September 2025

H-S 3212, Hay Rake, Action Hay rake, 12 wheel rake, like new

has hydraulic valve to rake with one side

New Skid Steer mount, shredder, 25 to 32 gallons per minute

853A John Deere row crop head ,new , sprockets, bearing out, 8 row 30", shaft broke

853A John Deere row crop head ,new sprockets, 8 row 30"

922B Cat runs good, moves very slow, may have a hydraulic problem

Salvage MF 175 Tractor, 2 remotes, 540 PTO, 16.9-28 tires, motor problems, new gasket set in shop

Vermeer MC1030, Hay Cutter, 2pt, 1000 PTO, 13ft wide, Conditioner, metal rollers

SKIDSTEER SNOW PLOW, 84IN WIDE

JD 8235R runs and drives, powershift, no def, has duals & hubs

Salvage Tractor, 3 Remotes, 1000 PTO, 20.8-38 Tires, TERP

Salvage Tractor, 2 Remotes, 1000 PTO, 20.8-38 Tires, TERP

Salvage Combine, 30.5L-32 front tires, 18.4-30 back tires. mud hog, 5211 hrs, TERP

Frame is welded back

New Holland HT 152 Hay Rake, pull type, 10 wheel rake, hitch and RH support welded

Armstrong RB3500-X Hay Spear, bucket mounted spear

Armstrong OSS-X Hay Spear, optional spear for PF Frame

Armstrong OSS-X Hay Spear, optional spear for PF Frame

Armstrong POSS18 Hay Spear, 18" stabilizer spear/hole

Armstrong POSS18 Hay Spear, 18" stabilizer spear/hole

IH 1460 Combine - good working condition, comes w 810 header, header pickup reel needs work

1975 Ford H48 Hydraulic Excavator, runs & drives

Johnsons 9693 Feederhouse Dust Diverter; hydraulic driven fan

J D 1610 Chisel, 26 Ft, bent shank, hitch slightly bent on left side, center cylinder not hooked up

John Deere 34, 1 Row Chopper

Loader w/brackets, 9ft bucket, skid steer attachment, fits MX180 Case IH tractor, MFD

hay spear sells separate

Grain Drill, pull type, 23 rows, 7in spacing, double blades, step on back bent, showing 4924 acres

Weight Bracket

Rear end off 5100 E John Deere Tractor, clutch housing and the final drive

7740 Ford, engine makes noise on top side, drives ok, Salvage, 2025 hours

560 Hesston baler, baled hay this year, actuator on twine has to be done manual, monitor

Three Axle farm Flatbed Trailer, has all 6 wheels, 2 wheels need tires,

and are on top of the trailer, pull type, 7.5ft wide, 32ft long, 9-ton capacity, tandem axle

YNM 3110, 4x4 Tractor, w/loader, 6' bucket, 4 WD, 12.4-26, has ROP, 540 PTO, refurbished

Runs & drives

YNM, 24FX Tractor, w/frontend loader, 5' bucket, 540, 11.2-24, 4WD, Refurbished , Runs & drives

6466 Engine Block With Camshaft, Crankshaft, & gears, R63198, R64530

Refurbished Case IH GPS system, with Trimble AgGPS NavController II (PN: 55563-00) and harness

Starter/alternator tester, it's dirty, but should clean up well, works

Industrial grade floor scrubbing machine, battery operated, comes with charger,

but needs new batteries, used in small convenience store

Commercial grade shop vac, 110v wet/dry vacuum with floor squeegee attachment,

20 gal, works great, used very little

Laminator 27 in wide, like new, comes with almost a full roll of film,

adjustable digital heat controller, built-in LED temperature display, adjustable supply roll tension, attached safety shield, heated silicone laminating rollers, reverse feature, adjustable feed table guide, works great

755 B Cat Salvage Tractor, Burnt

GB Loader with brackets, 7ft wide bucket, welds around pins ,fits 5130 Case IH MFD

fits 5130 Case IH MFD Tractor, quick attach bucket, bucket rusted

Bushhog 176 12' Blade, uses very little

Cat Challenger 85C, 4 hydraulic remotes, tracks, adjustable draw bar, 20 front weights

runs and drives, motor doesn't use oil, Tracks are worn & weather cracked

JD 230 Folding Disc, 24ft, 64 Disc, 9ft spacing

(8) 10ft Panels

10 row front mount 30in with track plow

Industrial Tractor loader, 3 pt, LH reverser, runs and drives

Self propelled sprayer, Ag Leader Monitor, 4023 hours, 90ft boom on 20" spacing

runs & operates

Vacuum Planter, 12 row, 38in spacing, trash whippers, hydraulic fold

JD 8560 Tractor, 3 remotes, duals, (20.8-38), 10805 hrs.

, Needs cab roof and seat, runs and drives, 6101 engine

Champion Generator, 7500 starting watts, 6000 running watts